RELEASE AGENTS & SEALERS
Confused about which product is right for your project? Contact us between 10am-4pm Monday to Friday through our Live Chat, phone (09) 846-7575 or email firstname.lastname@example.org.
The careful selection of sealers and/or release agents is essential to successful mold making and casting. As you will see, there are many ways these materials can be used separately or in conjunction with one another. Therefore, this guideline makes no guarantees regarding the success of any particular release or sealer. There is no substitute for adequate testing!
Please see Sealers and Release Agents Selection Guide
Inhibit X® is a single component, low-viscosity liquid that provides an added measure of protection against cure inhibition when pouring platinum silicone rubbers over many surfaces including sulfur clay, instant adhesives, tapes, wood surfaces, some plastics, SLA resins and others.
$119.95 ex GST
Super Seal and Ease release 205 4oz kit
$39.95 ex GST
EASE RELEASE 205 is a versatile liquid release agent that is used for a variety mold making and casting applications. This product will release liquid urethane rubber from cured urethane rubber and a variety of surfaces. It will also release silicone rubber from itself and a variety of surfaces.
$49.95 ex GST
One Step™ is a convenient, economical liquid sealing agent and release agent in one. This low odor, low viscosity formula is offered as a “one step” alternative to using a sealing agent followed by a release agent during the mold making process using Smooth-On urethane mold rubbers. One Step™ will facilitate the release of cured urethane mold rubber from plaster, concrete, stone, brick, marble, limestone, wood, metal and other surfaces. Do not use on modeling clays.
$60.83 ex GST
SuperSeal® was developed as an economical, fast-drying sealing agent for a variety of porous surfaces including gypsum plasters, concrete and wood.
$43.43 ex GST
Formulated especially for mold making and casting, Universal® Mold Release works well with most urethane liquid rubber and liquid plastic products. It will release mold rubbers from properly prepared models and also easily releases a variety of casting materials (epoxies, Smooth-On liquid plastics, etc.) from cured rubber molds.
$34.74 ex GST
Pol-Ease® 2300 Release Agent is a multi-purpose, silicone-based release agent in a convenient aerosol spray can. Excellent for Polyurethane moulding rubber.
$34.74 ex GST
Apply to non-porous or sealed models when making silicone rubber moulds (not recommended for use with liquid polyurethane rubbers). Apply to silicone rubber moulds when casting liquid silicone rubber.
$34.74$37.00 ex GST
Mold Lotion excellent for Plaster Moulds
$26.04$18.23 ex GST